LiteTouch Fittings Instruction Guide

1. Slide the nut, steel compression ring and PEEK^™ ferrule, in that order, onto the tubing. The side of the ring with the wider flat surface should face towards the nut and the narrow edged side of the ring towards the ferrule.
2. Insert into the receiving port. Hold the tubing to the bottom of the port while tightening down the nut. Tighten comfortably finger-tight. If you are using a wrench-tightened fitting, tighten 1/4-turn past finger tight for proper fitting operation.

Please Note: Not recommended for use in plastic receiving ports.